After extensive discussions in this forum, I was enlightened that the way to make the Start and End Time columns appear in CATS WDA ESS screen was to set the HIDE_CLOCK_TIMES_IN_WEEKLY parameter in the Application configuration from X to blank.
1) We copied the default Application configuration into Z.
2) Set the parameter to blank
3) updated LPD_CUST to point the relevant service to the Z configuration.
4) Tested extensively in development system, and everything worked a treat.
We have now transported the lot into QA system, however the clock times are hidden., and we get this messsage which has never appeared in DEV
"Selected columns could not be personalized"
We have verified the following
1) All transports have gone through in the correct sequence, and no failures or RC 8 and above have been reported.
2) On right clicking on the CATS WDA screen and going to Technical Help, the screen is definitely reading the Z configuration that we have transported
3) on reveiwing the Z configuration, we can see that the HIDE_CLOCK_TIMES_IN_WEEKLY parameter in the Application configuration is still blank.
What could possibly be wrong? Anyone seen this kind of thing before?
Thanks and Regards